GTM Owners Club Forum
http://www.gtmdrivers.com/forum/

Kano Coupe
http://www.gtmdrivers.com/forum/kano-coupe-t2891-195.html		 Page 14 of 26
Author:  kano nordie [ Wed Jul 05, 2017 6:40 am ]
Post subject:  Re: Kano Coupe
Dash as simple as it can get!!

Attachments:
GTM 3.jpg
GTM 3.jpg [ 78.19 KiB | Viewed 9091 times ]
Author:  kano nordie [ Wed Jul 05, 2017 6:41 am ]
Post subject:  Re: Kano Coupe
Front end from L side

Attachments:
GTM 5.jpg
GTM 5.jpg [ 103.67 KiB | Viewed 9091 times ]
Author:  kano nordie [ Wed Jul 05, 2017 6:42 am ]
Post subject:  Re: Kano Coupe
just to show I'm not biased now from the R side

Attachments:
GTM 6.jpg
GTM 6.jpg [ 93.03 KiB | Viewed 9091 times ]
Author:  kano nordie [ Wed Jul 05, 2017 6:44 am ]
Post subject:  Re: Kano Coupe
Dash, battery isolator, ignition and and starter button

Attachments:
GTM 7.jpg
GTM 7.jpg [ 97.85 KiB | Viewed 9091 times ]
Author:  kano nordie [ Wed Jul 05, 2017 6:46 am ]
Post subject:  Re: Kano Coupe
My cheap local purchase 50quid wheels fitted with 165-70 just to check clearances in case I cant find 60 series tyres :cry:

Attachments:
GTM 8.jpg
GTM 8.jpg [ 81.14 KiB | Viewed 9091 times ]
Author:  kano nordie [ Mon Jul 10, 2017 7:02 am ]
Post subject:  Re: Kano Coupe
One step forward at least 2 steps back, assembled my steering column with 2 U/J's to give a better alignment on my L-H drive installation, the good news is it does,"BUT" I now have a slight foul on the brake peddle, OK strip out the brake/clutch assembly, remove the brake peddle and put a little kink into the lever each side of the cut and shut joint, then found 1 of the brake cylinders on the bias bar assembly is seized, (it has been outside more than a year) so take the whole assembly into work where I have compressed air to blow the pistons out and to clean :roll:
John
Author:  Ken555 [ Mon Jul 10, 2017 11:17 am ]
Post subject:  Re: Kano Coupe
Need pics of column as that's on to do list.
Author:  kano nordie [ Mon Jul 10, 2017 12:13 pm ]
Post subject:  Re: Kano Coupe
Hi Ken,
The peddle box is at work being tweeked, if it all goes together OK next week I'll take some pictures, the biggest problem in L-H drive is there is not enough room to pass the column between brake and clutch peddles as would be normal in a Mini or R-H drive GTM, to give enough room for the brake and accelerator peddle next to the center tunnel the brake peddle must be to the left hand side of the column, big feet would end up at the chiropodist :oops:
John
Author:  Ken555 [ Mon Jul 10, 2017 5:22 pm ]
Post subject:  Re: Kano Coupe
kano nordie wrote:
Hi Ken, if it all goes together OK next week I'll take some pictures,


No rush, I'm currently sitting almost on the equator, not home for a few weeks as I work my way northwards.
Author:  kano nordie [ Tue Jul 11, 2017 5:57 am ]
Post subject:  Re: Kano Coupe
Hi Ken,
I'm not far above the equator, call in as you come north :lol: Star beer in the fridge.
John
Author:  kano nordie [ Mon Jul 17, 2017 7:25 am ]
Post subject:  Re: Kano Coupe
column with 2 u/j's

Attachments:
Peddle 1.jpg
Peddle 1.jpg [ 83.7 KiB | Viewed 8907 times ]
Author:  kano nordie [ Mon Jul 17, 2017 7:26 am ]
Post subject:  Re: Kano Coupe
column missing peddles

Attachments:
peddle 2.jpg
peddle 2.jpg [ 81.35 KiB | Viewed 8907 times ]
Author:  kano nordie [ Mon Jul 17, 2017 7:27 am ]
Post subject:  Re: Kano Coupe
"small' steering wheel??

Attachments:
peddle column 3.jpg
peddle column 3.jpg [ 82.7 KiB | Viewed 8907 times ]
Author:  kano nordie [ Mon Jul 17, 2017 7:27 am ]
Post subject:  Re: Kano Coupe
nether regions

Attachments:
rump 4.jpg
rump 4.jpg [ 98.7 KiB | Viewed 8907 times ]
Author:  kano nordie [ Mon Jul 17, 2017 7:28 am ]
Post subject:  Re: Kano Coupe
nether regions 2

Attachments:
rump 5.jpg
rump 5.jpg [ 98.1 KiB | Viewed 8907 times ]
Page 14 of 26 All times are UTC [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/