Hello all, in an attempt to put a stop to the constant hole cutting in my GTM, i was wondering if any body had any ideas about where to put the MSA curcuit breaker on a GTM? I was thinking on the inside of the "wings" that slope back from the rear window. MSA says:
"The triggering system for the circuit breaker on saloons should be situated at the lower part of the windscreen mounting, preferably on the driver’s side or
below the rear window." I assume this applies to little plastic sports cars too...
What do you think?

I have not had any need to look that bit of the Blur Book for a long time, but it was not a requirement in a road driven car, just mark the ignition switch with Dymo tape to show on/off positions?
wait a few minutes and Ken will tell you
John

Not needed in road going, but advised.



Afraid I cut a hole, threaded a bit of pipe and glassed it in.
Its a pull cable to the cut off on the tunnel in the middle.