GTM Owners Club Forum http://www.gtmdrivers.com/forum/ |
|
Coupe - Gear Box http://www.gtmdrivers.com/forum/coupe-gear-box-t4769.html |
Page 1 of 1 |
Author: | OzKen [ Tue Oct 25, 2022 4:45 pm ] |
Post subject: | Coupe - Gear Box |
Hi, I have a remote cast gear change on my Coupe and I’m struggling to make clean gear selections, especially first gear. Would I be better changing my gear box for a twin shaft change type? Has anyone had any experience changing these over and if so, were the gear selections significantly better? I have a nice newly made bit of gear change kit from Alan Britton ready for the twin shaft change if need be! Thanks for any advice anyone can offer ! |
Author: | kano nordie [ Wed Oct 26, 2022 7:44 am ] |
Post subject: | Re: Coupe - Gear Box |
Hi Ken I used the old cut in half remote change on my old Cox long and found the changes OK apart from slipping into the reverse slot on hurried gear changes, I fitted a hinged lockout to cure this. Mini Spares do a spring load kit that pushes the gear leaver into the 1st-2nd slot, but as I've not tried it can't comment if its better. I'm sure Alan's rod change Kit will be better if you change the box, I use a twin shaft change but pass the selector shaft through the front of the box not underneath. John |
Author: | OzKen [ Wed Oct 26, 2022 12:13 pm ] |
Post subject: | Re: Coupe - Gear Box |
Hi John, That’s very helpful, thanks for that. I’ll check it all out. Fingers crossed! Thanks again Ken |
Page 1 of 1 | All times are UTC [ DST ] |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |