GTM Owners Club Forum
http://www.gtmdrivers.com/forum/

K Series rebuild
http://www.gtmdrivers.com/forum/k-series-rebuild-t3663.html		 Page 1 of 1
Author:  Jaykart1227 [ Sun Jan 08, 2017 6:30 pm ]
Post subject:  K Series rebuild
Hi all,

I put together my new k series bottom end this morning in anticipation of the modified cylinder head being ready to collect soon. Nothing too unusual in that of course but I thought I'd put some pictures up as I'm using a brand new uprated spec stiffer block and you can really see the additional webs whilst the engine is bare.

Used new 160 pistons, liners, mahle motorsport bearings, oil pump, water pump.

Attachment:
IMG_0149.jpg
IMG_0149.jpg [ 86.42 KiB | Viewed 8645 times ]

Attachment:
IMG_0154.jpg
IMG_0154.jpg [ 81.21 KiB | Viewed 8645 times ]

Attachment:
IMG_0150.jpg
IMG_0150.jpg [ 73.38 KiB | Viewed 8645 times ]

Attachment:
IMG_0151.jpg
IMG_0151.jpg [ 85.15 KiB | Viewed 8645 times ]
Author:  West [ Sun Jan 08, 2017 8:21 pm ]
Post subject:  Re: K Series rebuild
Some good progress

Out of interest what is the wall thickness of the liners, just interested.

Neil
Author:  Jaykart1227 [ Sun Jan 08, 2017 9:14 pm ]
Post subject:  Re: K Series rebuild
Hi Neil,

Just measured them and they're 4mm thick at the top. Probably about 2mm below the shoulder as these are damp liners.

Cheers, Jamie
Author:  West [ Mon Jan 09, 2017 2:34 pm ]
Post subject:  Re: K Series rebuild
thanks.
Page 1 of 1 All times are UTC [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/