GTM Owners Club Forum http://www.gtmdrivers.com/forum/ |
|
Advice request, seal for k-series 1400 MPI Throttlebody Seal http://www.gtmdrivers.com/forum/advice-request-seal-for-k-series-1400-mpi-throttlebody-seal-t2165.html |
Page 1 of 1 |
Author: | peter_peterborough [ Sun Dec 04, 2011 8:39 pm ] |
Post subject: | Advice request, seal for k-series 1400 MPI Throttlebody Seal |
Hi If anyone can advise re a supplier for the thick rubber seal that bolts (on engine side) of the Fuel Injection Throttle body (mine is cracked), on the 1400cc MPI K-series engine fitted to My Rossa K3, see photo on link below, I would be very grateful. Many thanks. Photo at: http://www.peterboroughareaweddings.co. ... tes/gtmk3/ |
Author: | bob snooks (835) [ Sun Dec 04, 2011 11:29 pm ] |
Post subject: | Re: Advice request, seal for k-series 1400 MPI Throttlebody Seal |
A member that lives near me has just ordered one of these from SMC [Slough Motor Co] ex Rover dealers, or you could try Rimmer Bros. Bob. |
Author: | Steve Shield [ Mon Dec 05, 2011 11:28 am ] |
Post subject: | Re: Advice request, seal for k-series 1400 MPI Throttlebody Seal |
Peter, You need to get this fixed asap -- the throttle body on my Libra fell off -- yes really! -- leaving me with a maxed out engine which seems to be ok and stranded at the local tip of all places. An off-duty RAC man fixed up a temporary repair with sealant and two tie-wraps. I got a new unit from a local dealer who's now stocking MG although I think Bob is right that Rimmers have the part. Prepare for a financial shock as it £88 including VAT. Also the rubber seems softer and the design is still sh*t, relying on a bonded surface. If you're running a K&N filter I think it probably needs a bit more support on the throttlebody side |
Author: | peter_peterborough [ Tue Dec 06, 2011 10:05 pm ] |
Post subject: | Re: Advice request, seal for k-series 1400 MPI Throttlebody Seal |
Thankyou Bob and Steve for your advice. I must say I am really surprised by the price - for that part that seems excessive. O well, I guess I have no choice (unless any forum members know of a cheaper supplier? - as it sounds as if even the expensive ones are of questionable quality.) Thanks again. Regards Peter |
Author: | DavrianMad [ Tue Dec 06, 2011 10:54 pm ] |
Post subject: | Re: Advice request, seal for k-series 1400 MPI Throttlebody Seal |
I had the same problem and in the end changes the inlet manifold to VVC unit, cheaper in long run. |
Page 1 of 1 | All times are UTC [ DST ] |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |