|
|
|
|
It is currently Thu Apr 25, 2024 8:13 am
|
View unanswered posts | View active topics
|
Page 1 of 1
|
[ 4 posts ] |
|
Anti roll bars measurements
Author |
Message |
West
Admin, and Coupe Nutter
Joined: Fri Sep 14, 2007 10:34 pm Posts: 1762 Location: In the workshop GTM: Cox/Coupe
|
Anti roll bars measurements
Right K3'ers I have a question for you.
I am ideally looking for some dimensions of a MGF or TF front and rear anti roll bar and as some of you use MGF bits I was hoping I could get some measurements.
so any one able to help?
Neil
_________________ IF wile e coyote had a GTM he would have one with Nitrous too! watch out road runner! The First GTM into the 11s then the 10s, PB 10.87 @ 125.5 Mph on A048 tyres, and fully road legal at Santa Pod
|
Sat Sep 16, 2017 4:51 pm |
|
|
PEEPS
Part built GTM
Joined: Mon May 03, 2010 10:56 pm Posts: 145 GTM: K3
|
Re: Anti roll bars measurements
I was just about to go to bed but you made me go in the garage with a tape measure!! MGF front roll bar is 19mm diameter,880mm centre width and ends cranked down at 117 degrees 300mm long giving an outside measurement of 1080mm. There is a 10mm hole in each end 20mm in from the end. (this would be easier if I knew how to post a drawing) Rear roll bar is a cranked shape this time 18mm diameter, centre length 880mm, cranked down each side at 115 degrees for 150mm then parallel with the top bar for 90mm, then cranked down at 90 degrees for 100mm. Overall width1290, internal 1270. The ends again have a 10mm dia hole to take a 50mm centre to centre drop link to the rear hub. There is a picture of my rear anti roll bar in a previous post showing the end detail. I have a front and rear going spare if anyone wants them freebies for collection. Peter.
|
Sat Sep 16, 2017 11:13 pm |
|
|
West
Admin, and Coupe Nutter
Joined: Fri Sep 14, 2007 10:34 pm Posts: 1762 Location: In the workshop GTM: Cox/Coupe
|
Re: Anti roll bars measurements
That is commitment Peter!
Very useful info will have to have a measure up.
Where about are you as could be interested in the front bar
Neil
_________________ IF wile e coyote had a GTM he would have one with Nitrous too! watch out road runner! The First GTM into the 11s then the 10s, PB 10.87 @ 125.5 Mph on A048 tyres, and fully road legal at Santa Pod
|
Mon Sep 18, 2017 12:51 pm |
|
|
PEEPS
Part built GTM
Joined: Mon May 03, 2010 10:56 pm Posts: 145 GTM: K3
|
Re: Anti roll bars measurements
Hi Neil, Junction 30 M1 just before Sheffield. Peter.
|
Mon Sep 18, 2017 4:55 pm |
|
|
|
Page 1 of 1
|
[ 4 posts ] |
|
Who is online |
Users browsing this forum: No registered users and 2 guests |
|
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum
|
|
|
|