Ok so I can’t post on my K3 thread due to blank screen syndrome but I’ve found I can start another topic so here goes. I now have the coilover brackets for the front end ( thanks Peter ) and I’ve removed the junk from the offside of the car ready to fit the first bracket. I’m hoping to order the coilovers and springs tomorrow but I need to know what size bonded bushes I need in the coilovers. The holes in the top of the mounting bracket will take an M12 bolt which is no problem but the hole in the upper arm will only take an M10. I don’t think it’s wise to drill the arm out to take an M12 so any suggestions? Do I order with an M12 top bush and an M10 bottom bush or is there an alternative way of doing this? I’ve measured the gap in the upper mounting at 34mm. Does that sound right? When I rang Larkspeed they wanted so much info it was like twenty questions
Any help would be appreciated.