GTM Owners Club Forum http://www.gtmdrivers.com/forum/ |
|
Hose GRH1104 http://www.gtmdrivers.com/forum/hose-grh1104-t4486.html |
Page 1 of 1 |
Author: | nikvanorton [ Thu May 21, 2020 3:42 pm ] |
Post subject: | Hose GRH1104 |
Is there a newer or alternative part number for the above hose? I can't seem to find it available anywhere in the UK. Thanks. |
Author: | jaybee [ Thu May 21, 2020 4:13 pm ] |
Post subject: | Re: Hose GRH1104 |
You can still get them in the EU. https://www.recambiosprom.com/tienda/Ma ... 2001394_gp J. |
Author: | Tim Rowe (1130) [ Thu May 21, 2020 4:14 pm ] |
Post subject: | Re: Hose GRH1104 |
Rimmer brothers suggests this as an alternative: https://rimmerbros.com/Item--i-PCH10250EVA Hope this helps. |
Author: | sidewinder [ Thu May 21, 2020 10:39 pm ] |
Post subject: | Re: Hose GRH1104 |
What exactly do you want the hose for? It's mostly just cut up to provide 90° angles. |
Author: | nikvanorton [ Thu May 21, 2020 10:39 pm ] |
Post subject: | Re: Hose GRH1104 |
It's to replace the hose between the steel coolant pipe from the thermostat (that goes around the engine under the inlet manifold) to the alloy tube near the bulkhead that disappears off to the radiator. It's just a 45 degree bend section cut out of the hose and since both the GRH1104 and PCH10250EVA seem to be out of stock everywhere I've found this which should work in 32mm. https://www.thehosemaster.co.uk/45-elbo ... ator-hose/ |
Author: | roger [ Fri May 22, 2020 11:14 am ] |
Post subject: | Re: Hose GRH1104 |
Have a look at Eliseparts. They have pretty much everything in silicon https://www.eliseparts.com/shop/engine- ... one-hoses/ |
Author: | sidewinder [ Fri May 22, 2020 12:41 pm ] |
Post subject: | Re: Hose GRH1104 |
When I had standard thermostat, I replaced that whole bit with a PEH100820 which eliminated a bunch of joins. It did need a reducer to fit on the underfloor ally pipe which is 28mm OD but hose is 32mm ID. |
Author: | nikvanorton [ Fri May 22, 2020 11:33 pm ] |
Post subject: | Re: Hose GRH1104 |
sidewinder wrote: When I had standard thermostat, I replaced that whole bit with a PEH100820 which eliminated a bunch of joins. It did need a reducer to fit on the underfloor ally pipe which is 28mm OD but hose is 32mm ID. I like the sound of that, thanks. |
Page 1 of 1 | All times are UTC [ DST ] |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |