I have been trying to adjust the rear camber on my spyder but on reading the instructions for the adjustment I just cant understand how the camber is adjusted. I am using these instructions:
"Referring to the diagram and looking from the back of the car set the dimension five 550 millimetres on the driver’s side of the car from the face of the casting where the driver shaft protrudes to the centre nearest bolt on the bottom wishbone. To obtain this adjustment it is necessary to adjust only the bottom wishbone with the two locking nuts on the outside ball joint and then readjust the top wishbone to obtain the correct camber angle"
I am at a loss to identify the bolt on the bottom wishbone as I think there are 3 bolts where i think they are referring to, and I cant make out where the two locking nuts on the outside ball joint and where do I make the adjustment on the top wishbone? Can anyone help with some pics or drawing of the location of the mentioned nuts and bolts as I am tearing hair out trying to make sense of the instructions
Many thanks to anyone who can help
Brian