GTM Owners Club Forum http://www.gtmdrivers.com/forum/ |
|
Suspension Coupé http://www.gtmdrivers.com/forum/suspension-coupe-t3245-15.html |
Page 2 of 2 |
Author: | Yoda74 [ Fri Oct 30, 2015 10:41 am ] |
Post subject: | Re: Suspension Coupé |
I just did some measurements and took a look at the lower front arms. The arms are welded and have reinforcements. If I measure hart to hart of the weldings, I measure aprox 13 mm, that's about 1/2". The rubbers/ bushes of the lower arms and tierods had their best time. The tierods are both a bit bend, not very straight. I measured the groundclearance from the sill down. In the front it was aprox 105mm, that is 4 1/8" In the back there is more space, about 130mm, that is 5 1/8" A bit low, it looks nice, but the bottom already hit a few speedbumps, even when going very slow. What is the best way to go? The back has HiLo's, so I can raise the back. The front is a different story, go with some new rubbers, bushes and rubber cones and see where we stand then, or buy HiLo's, and the minispares mssk3013 kit? I have to get a good allignment in an allignmentworkshop then. Does anybody know if I can order at minispares from Holland? It seems a lot cheaper then when I get the same goods over here. Cheers Harold |
Page 2 of 2 | All times are UTC [ DST ] |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |