Need some of the metal fastners that hold bonnet and rear clam shell down. Bronze look thick washer with flush fitting bolt with allan key top. Any idea where to get them please?

Also metal radiator pipe, drivers side, from top of radiator. Probably a metro part that is cut to fit.

With thanks.

Can't help with the originals, but these are very nicely made and about the same size.

http://www.tegiwaimports.com/select-car ... -32mm.html

I got a load of replacements from demon tweaks.

I got my screws from ebay. Just search for 'M6 countersunk stainless allen'. I bought some 16mm & some 20mm ones.
Can't help with the washers as i re-used the ones i had.

My original washers were ally and fixings M6 csk stainless. Look on ebay for "countersunk washer aluminium" or "countersunk washer stainless" the 'turned' ones are similar to stock.

Radiator pipe is #6 cut down http://www.rimmerbros.co.uk/Item--i-GRID000433 as per the original instructions.

Though, the side branch (that goes to the back of the car to the header tank) could do with being positioned higher on the tube to aid prevention of air in the top of the rad.

Someone on here did just such a mod: radiator-change-t3207-15.html?hilit=radiator pic of it on this thread somewhere.

SAS

Thank you all for help.

I got mine from pro bolt in stainless

https://www.pro-bolt.com/stainless/stai ... rsunk.html

I ended up using plain flat washers and dome headed bolts could not be bothered faffing with countersunk bolts and washers (hard luck Ian )